Here’s how to retrieve an error code without using special tools. Turn the bike OFF with the key but turn the kill switch ON. Press and hold the instrument SET button and instrument UP button while turning the key on. After a few seconds an error code will be displayed on the instrument panel.
The spindle for the front wheel requires a 17mm hex head to remove. Reinstall and tighten the spindle to 65Nm and the pinch bolts to 22Nm. Note the right hand spacer is longer than the left and has two machined rings on it.
If you’re installing a module between the wiring harness and rear brake light, like a flasher module, you can use an electrical connector rather than cutting and splicing wires. The rear brake light connector is a 3 Way Econoseal J Series connector from AMP. It can be purchased from http://www.bmotorsports.com
Sometimes the Neutral light will not turn on when the gearbox is engaged in neutral. This is usually a sign of a faulty gear position indicator which can easily be replaced.
This will also prevent the bike from starting with the kickstand down. Lifting the kickstand up and holding the clutch in will allow the bike to start without the neutral light.